EIGRP Enabler #3

Wendell
By Wendell March 20, 2017 12:05

The goal is to get so good at your OSPF and EIGRP network commands that you get bored with all these exercises. There yet? If not, here’s another. As always with the EIGRP and OSPF Enabler exercises, your job: read and react to a set of requirements to then choose how to configure about a dozen network commands. Simple, useful, do it and move on to the next thing!

Initial State: Topology

Figure 1 shows the topology for this exercise, with four routers connected in a square, each with one extra LAN interface.

EIGRP Enabler Topology

 

Initial State: Interfaces and Routing Protocol

Each of the routers has an initial configuration that includes IPv4 addresses, working interfaces, and EIGRP configured to shows its autonomous system number. Examples 1, 2, 3, and 4 show that configuration.

Router R1 Initial Configuration

 

Router R2 Initial Configuration

 

Router R3 Initial Configuration

 

Router R4 Initial Configuration

 

Your Job: Complete the Configuration with network Commands

To finish the configuration, add EIGRP network commands to each router’s configuration.  By the end of this exercise, a real network with the combined initial config, plus your config, should result in:

  • EIGRP neighbor relationships between each pair of routers, so that each router has two EIGRP neighbors.
  • Each router has learned routes to all subnets in the figure.

 

Configure Your Commands Per These Specific Rules

Use the following requirements when configuring your EIGRP network commands.

 

R1 –  Match the Subnet: On router R1, make each network command match all addresses in a single subnet. Use wildcard masks as needed, and use as many network commands as needed to enable EIGRP on all interfaces shown in the figure.

R2 –  Match the Interface Address: On router R2, make each network command match one specific IP address. Use wildcard masks as needed, and use as many network commands as needed to enable EIGRP on all interfaces shown in the figure.

R3 –  Match the Subnet: Same rules as on router R1.

R4 – Match the Network: On router R4, make each network command match all addresses in a single classful network (that is, in a single class A, B, or C network.) Use wildcard masks as needed, and use as many network commands as needed to enable EIGRP on all interfaces shown in the figure.

Note that this exercise is not like what real network engineers do in their jobs. In real networks, you would probably use the same approach on each router.

 

Answers!

I will post an answer post in a few days. So, look for the link at the bottom of this page.

 

Do this Exercise as a Lab with VIRL

Are you thinking that you’d like to just do this exercise with VIRL, instead of on paper, or just typing in an editor? We already built the topology and initial configuration. Just click below to get the .VIRL file.

EIGRP Enabler 3 VIRL – Initial State

EIGRP Enabler #3 - Answers
OSPFv2 Enabler #3 - Answers
Wendell
By Wendell March 20, 2017 12:05
Write a comment

No Comments

No Comments Yet!

Let me tell You a sad story ! There are no comments yet, but You can be first one to comment this article.

Write a comment
View comments

Write a comment

Comment; Identify w/ Social Media or Email

Subscribe

Subscribe to our mailing list and get interesting stuff and updates to your email inbox.

Thank you for subscribing.

Something went wrong.

Search

Categories