OSPF Interface Config – Answers (Config Museum)

certskills
By certskills December 12, 2014 09:05

Today’s post shows the config for this latest Config Museum practice problem, with some commentary about how to configure OSPF per-interface. It helps to start with the problem statement, found in the previous Config museum post from a few days ago. As usual, no guile, no tricks, just a chance to exercise.

 

First: The Answer

The next three examples show the literal answers. To start, check your answers versus these answers; following the examples, I’ll make a few comments about options. Here’s a quick repeat of the figure, for reference:

 

Figure 1: Router Triangle with Sample IP Addresses for Calculations

 

Example 1: R1 Config

 

Example 2: R2 Config

 

Example 3: R3 Config

 

Commentary

Normally with Config Museum labs we just post the answer without much commentary, but this one begs for a few comments.

First, on the core point of using interface subcommands, two parameters must be chosen for the ip ospf interface subcommand. However, the choices are relatively basic. One parameter is the OSPF router process ID, as found on the router ospf command. The other is the OSPF area number to which the interface is assigned, and in this lab, all are assigned to area 0.

The rest of the possibly-tricky parts have nothing to do with the OSPF interface configuration.

For the OSPF router IDs, the instructions asked you to set them to something obvious, but it didn’t require you to use any particular method. The answers show two methods: directly setting the RID (routers R1 and R2), and using the router’s highest loopback IP address (router R3). But your answer could use either of those two methods, or it could have relied on a non-loopback interface IP address.

Finally, the OSPF process IDs do not have to match. Just to make that point, the answers lists here use different process IDs. However, any literal value within the allowed range (from 1 through a pretty large number) could have been used.

OSPFv2 Interface Configuration (Config Museum)
Config VM: Fallback Static Routes
certskills
By certskills December 12, 2014 09:05
Write a comment

No Comments

No Comments Yet!

Let me tell You a sad story ! There are no comments yet, but You can be first one to comment this article.

Write a comment
View comments

Write a comment

Comment; Identify w/ Social Media or Email

Subscribe

Subscribe to our mailing list and get interesting stuff and updates to your email inbox.

Thank you for subscribing.

Something went wrong.

Search

Categories