EIGRP and Bandwidth

Wendell
By Wendell August 25, 2015 09:05

EIGRP trades basic information about subnets, along with metric components, allowing routers to calculate the best route to each subnet. Those components include bandwidth and delay. In this lab, you will practice EIGRP configuration, while changing the bandwidth in one case to influence the routes chosen by EIGRP in a sample network.

Requirements

Configure EIGRP on all devices so that EIGRP chooses the best paths based on the expected speeds of each link. The figure shows the expected speeds. This lab begins with all the interfaces shown in Figure 1 working and with IPv4 addresses configured.

The specific rules for this lab are:

  • Use ASN 10
  • Set the bandwidth on all interfaces to match the speeds in the figure
  • Assume all interfaces in the figure are up and working
  • Assume all IPv4 addresses implied in the figure are configured, and neighbors are pingable
  • Use all defaults unless otherwise required to accomplish the lab requirements

 

Figure 1: Router Triangle with IP Subnets

 

Initial Configuration

While you might be able to configure EIGRP based on the information supplied so far, the initial configurations of the three router can also be helpful. Example 1, 2 and 3 show the beginning configuration state of R1, R2 and R3.

Example 1: R1 Config

 

Example 2: R2 Config

 

Example 3: R3 Config

 

It’s Now Time for Your Answer

Next, write your answer on paper. Or if you have some real gear, or other tools, configure the lab with those tools.

 

Do this Lab with Cisco’s VIRL

You can do these labs on paper and still get a lot out of the lab. As an extra help, we have added files for the Virtual Internet Routing Lab (VIRL) software as well. The .VIRL file found here is a file that when used with VIRL will load a lab topology similar to this lab’s topology, with the initial configuration shown in the lab as well. This section lists any differences between the lab exercise and the .VIRL file’s topology and configuration.

Download this lab’s VIRL file!

 

Network and Host Device Info:

The .VIRL topology matches this lab topology exactly. The host info does as well.

 

Handy Host Commands:

To see PC IP address: ifconfig eth1

Ping example: ping -c 4 10.1.1.1

Trace example: tracepath 10.1.1.1

To connect to another node within the topology: telnet 10.1.1.1

Answers: Basic Port Security
Answers: EIGRP and Bandwidth
Wendell
By Wendell August 25, 2015 09:05
Write a comment

No Comments

No Comments Yet!

Let me tell You a sad story ! There are no comments yet, but You can be first one to comment this article.

Write a comment
View comments

Write a comment

Comment; Identify w/ Social Media or Email

Subscribe

Subscribe to our mailing list and get interesting stuff and updates to your email inbox.

Thank you for subscribing.

Something went wrong.

Search

Categories