Basic NetFlow 2

Basic NetFlow 2

🕔09:05, 30.Nov 2015

Cisco added three small network management topics to CCNA R&S for the in 2013 (exams 100-101, 200-101, 200-120). Today’s lab gives you configuration practice with one of those: NetFlow. NetFlow provides routers with the capability to capture statistics based on

Read Full Article
Answers: IPv6 Addressing with OSPFv3

Answers: IPv6 Addressing with OSPFv3

🕔09:05, 19.Nov 2015

In this lab, you will configure global unicast addresses, rely on link local addresses only on some links, and use OSPFv3 to learn routes to the global unicast prefixes. Ready to check your work in this long-ish lab? If not,

Read Full Article
IPv6 Addressing with OSPFv3

IPv6 Addressing with OSPFv3

🕔09:05, 17.Nov 2015

For this latest lab, you configure IPv6 routing, addressing, and OSPFv3, all in one small lab. This next lab is rather long by comparison to most others in this series – it might take you 10-15 minutes rather than the

Read Full Article
Answers: Trunking for Only Some VLANs

Answers: Trunking for Only Some VLANs

🕔09:05, 4.Nov 2015

Time to check your config versus this latest lab. Do you recall the command and syntax to restrict a trunk on a Catalyst switch from supporting all VLANs? Go try the lab yourself on paper, then come back here and

Read Full Article
Trunking for Only Some VLANs

Trunking for Only Some VLANs

🕔10:30, 2.Nov 2015

VLAN trunks between Cisco Catalyst switches support all VLANs known to the switches. Then add a new VLAN, and the trunk supports it. Is that a good idea? In this post, you will get a chance to practice that common

Read Full Article

Subscribe

Subscribe to our mailing list and get interesting stuff and updates to your email inbox.

Search

Categories