Answers: OSPF Networking Config 1

Answers: OSPF Networking Config 1

🕔09:05, 23.Sep 2015

OSPF network commands challenge all of us when first learning OSPF. Should you master ACLs, and then return back to OSPF? Just forge ahead with OSPF? This most recent lab gives you practice with the OSPF network command and with

Read Full Article
OSPF Network Config 1

OSPF Network Config 1

🕔09:05, 21.Sep 2015

The OSPF network command can cause a bit of mental trouble for anyone just starting out. The reason: the first two parameters require us to do a little math, compare that result to the router’s interface IP addresses to then

Read Full Article
Answers: Basic NetFlow 1

Answers: Basic NetFlow 1

🕔13:05, 16.Sep 2015

Informally, these labs are like any repetitive types of practice when learning a sport. Basketball players take lots of jump shots, soccer players practice long and short passing drills, baseball players take grounders, etc. And the best of the pros

Read Full Article
Basic NetFlow 1

Basic NetFlow 1

🕔09:05, 14.Sep 2015

NetFlow serves a great purpose in Cisco devices, first analyzing and keeping statistics of packets passing through the device, and then forwarding those statistics on to a NetFlow Collector for later analysis. However, from a #CCNA exam prep perspective, NetFlow

Read Full Article
Answers: Serial Config 1

Answers: Serial Config 1

🕔09:05, 10.Sep 2015

Time to check your config for a back-to-back serial link in a lab. Check out the requirements back in the lab post, create your answers, and come back here to check your work.

Read Full Article
Serial Config 1

Serial Config 1

🕔09:35, 8.Sep 2015

Take two routers in a lab, both with serial interfaces, and connect them with a back-to-back serial cable. Do you remember the details of how to configure both routers so that both routers can ping each other? Today’s lab provides

Read Full Article
Answers: Basic OSPFv3

Answers: Basic OSPFv3

🕔09:05, 4.Sep 2015

This lab asks you to configure OSPFv3 for an IPv6 network, from a starting point of having all the IPv6 addresses configured on the routers in the network. For this lab, you add a few optional parameters in addition to

Read Full Article
Basic OSPFv3

Basic OSPFv3

🕔09:05, 1.Sep 2015

When used for IPv6, OSPF uses a straightforward interface-focused configuration. As a result, you do not even have to know the IPv6 addresses or subnets when configuring OSPF – all you have to know is which interfaces are in which

Read Full Article

Subscribe

Subscribe to our mailing list and get interesting stuff and updates to your email inbox.

Thank you for subscribing.

Something went wrong.

Search

Categories